MyEssentials 7-Port High-Speed USB 2.0 Hub

Contra the report under 'Problem Hubs' below, I do not have any trouble with wired ethernet on a Model B pi, 3.x linux kernel. This is the same chip used as in the Pimoroni PiHub. My REV:2.4 has a GL852G chip, which makes it a proper MTT hub. However, I've attached a HD that requires 850 mA and it worked fine. The user manual says “Per Port Current Self-Powered Mode: 500mA (max)”. With the USB output of the RPi connected to the one 'B' port PSU 6v 4A Powering a 256 'A' RPi with the hub. The PSU for the hub is a 2.5A 5v made in china. Powers the pi quite well, 4.85V across TP1&2 during idle and load. Seems very good, tested with: a keyboard, a mouse, a numpad and an Xbox joypad 4-Port HUB (with external power source soldered on)Īn external 5V power source** has to be soldered on the VBUS and GND lines USB2.0 Hub 4-port bus powered 4xUSB A/F 1xUSB A/M / Terminus Technology Inc. 7 port USB 3.0 Hub with built in charging portĠ.9A per port, 1.5A on BC 1.2 charge portĭoes not backpower, external 12v supply.

Gl850a Usb Hub Driver